Brocade Network Advisor IP User Manual v12.1.0 User Manual
Page 1560
1506
Brocade Network Advisor IP User Manual
53-1002947-01
Database tables and fields
I
TABLE 291
MPLS_PATH_HOP
Field
Definition
Format
Size
MPLS_PATH_HOP_DB_ID
Unique database generated identifier.
int
HOP_INDEX
Index of the MPLS hop.
int
HOP_IP_ADDRESS
The Tunnel Hop Address for this tunnel hop.
varchar
255
HOP_TYPE
Denotes whether this tunnel hop is routed in a strict or loose
fashion. Possible Values are Strict-1 and Loose-2.
smallint
MPLS_PATH_DB_ID
Database ID of the MPLS_PATH Instance which this hop is
part of.
int
TABLE 292
MPLS_RSVP_LSP
Field
Definition
Format
Size
MPLS_LSP_DB_ID
Unique database generated identifier.
int
IS_ENABLED
Represents whether the LSP is enabled. Enabled-1,
Disabled-0.
num
(1,0)
IS_BYPASS
Represents if the LSP is a Bypass LSP or not. Not a
Bypass-0, Bypass LSP-1. Currently ByPass LSPs are not
supported. So the value will be always 0.
num
(1,0)
FROM_IP_ADDRESS
Represents the Source IP Address of the LSP.
varchar
255
METRIC
Represents the metric of the LSP used by the routing
protocols to determine the relative preference among
several LSPs towards a given destination. Accepts a range
of 1 - 65535.
int
PATH_SELECT_MODE
Specifies the path selection mode to use. Refer
mplsLspPathSelectMode MIB of foundry.mib for more
details and possible values.
smallint
PATH_SELECT_PATH
The user-selected pathname when the Path Selection mode
is either Manual or Unconditional. If the device returns null
or empty string, this value would be primary.
varchar
255
REVERT_TIMER
The number of seconds to wait after the primary or selected
path comes up before traffic reverts to that path. A value of
0 indicates that it will switch immediately after the current
working path goes down. The range of values supported are
0-65535.
int
TIE_BREAKING_MODE
Specifies the tie breaking mode for selecting the
Constrained Shortest Path First(CSPF) equal-cost paths.
Possible values are Random-1, LeastFill-2 and MostFill-3.
smallint
IS_USE_LSP_FOR_OSPF_SHOR
TCUTS
Indicates that this LSP allows shortcut between nodes in an
AS. OSPF includes the LSP in its SPF calculation. Possible
values are Not Allowed-0 and Allowed-1.
num
(1,0)
IS_USE_LSP_FOR_ISIS_SHORTC
UTS
Flag to indicate if the LSP is to be used by ISIS destinations. num
(1,0)
LSP_FOR_ISIS_SHORTCUTS_LE
VEL
ISIS level to which the LSP is advertised into
int
LSP_FOR_ISIS_SHORTCUTS_RE
LATIVE_METRIC
Add or subtract relative metric.
int