Brocade Network Advisor IP User Manual v12.1.0 - Manual (Page 688)

634 Brocade Network Advisor IP User Manual
53-1002947-01
Layer 3 access control list policy
20
• To enter an IP address, select IP Address and complete the following steps:
a. Enter the destination IP address on which the ACL filters traffic in the IP Address list
and text field.
b. Enter a portion of the destination IP address on which the ACL filters traffic in the
Wildcard Mask field.
• To select a network, select IP Address and choose a network from the list.
To configure a network, click the ellipsis button and refer to “Network configuration” on
page 649.
• To enter a host name, select Host and enter the destination host name on which the ACL
filters traffic in the Host list and text field.
9. Enter a VLAN identifier (valid values are from 1 to 4095) from the VLAN list.
10. Select the Log Enable check box to enable logging.
11. Click Advanced Settings to configure additional settings for the ACL configuration.
NOTE
You must configure advanced settings to create an extended Layer 3 ACL.
The L3 ACL Advanced Settings dialog box displays. To configure additional settings, refer to
“Configuring L3 ACL advanced settings” on page 645.
12. Click the right arrow button.
The new ACL displays in the ACL Entries list.
13. Use the Up and Down arrow buttons to rearrange the ACLs in the ACL Entries list.
14. View the advanced settings for an ACL by selected the ACL in the ACL Entries list and clicking
View.
The L3 ACL Advanced Settings dialog box displays.
15. Click Close on the L3 ACL Advanced Settings dialog box to close.
16. Click OK on the Add - L3 ACL Configuration dialog box.
The new ACL displays in the ACLs list.
17. To set the configuration type and operations, refer to “Configuring the ACL configuration type
and operations” on page 644.
18. (Ethernet routers only) To set the hit statistics duration, refer to “Configuring hit statistics” on
page 644.