Viewing existing services – Brocade Network Advisor IP User Manual v12.1.0 User Manual
Page 713
Brocade Network Advisor IP User Manual
659
53-1002947-01
Layer 3 access control list policy
20
Viewing existing services
You can access the Service dialog box when configuring an extended L3 ACL device configuration.
To configure an extended L3 ACL, refer to one of the following procedures:
•
“Creating an extended L3 ACL configuration”
•
“Editing an extended L3 ACL configuration”
•
“Copying an extended L3 ACL configuration”
•
“Creating an extended L3 ACL configuration”
•
“Editing an IPv6 L3 ACL configuration”
•
“Copying an IPv6 L3 ACL configuration”
To view all existing services, complete the following steps.
1. Click the Services tab.
FIGURE 232
Service dialog box, Services tab
2. Review the List of Services table:
•
Name — The service name.
•
Protocol — Whether the service uses the TCP or UDP protocol.
•
Port — The port number.
•
User-defined — Whether the service is user-defined or not.
3. Click Close on the Network dialog box.
To finish configuring the advanced settings, refer to