Brocade Network Advisor IP User Manual v12.1.0 - Manual (Page 755)

Brocade Network Advisor IP User Manual 701
53-1002947-01
Zoning configuration
21
6. Press Enter to save the new name.
7. Click OK or Apply to save your changes.
Any zones or zone configurations you have changed are saved in the zone database.
Deleting a zone configuration
1. Select Configure > Zoning > Fabric.
The Zoning dialog box displays.
2. Click the Zone DB tab if that tab is not automatically displayed.
3. Select a fabric from the Zoning Scope list.
This identifies the target entity for all subsequent zoning actions and displays the zoning
database for the selected entity.
4. Select one or more zone configurations in the Zone Configurations list that you want to delete,
then right-click and select Delete.
A message displays asking you to confirm the deletion.
5. Click Yes to delete the selected zone configuration.
The message closes and the selected zone configurations are removed from the Zone
Configurations list.
NOTE
If you select “Do not show me this again.” on the confirmation message, the next time you
delete a zone configuration, it will be deleted without requesting confirmation from you. If you
delete something in error, click Cancel on the Zoning dialog box to exit without saving changes
since the last operation (Apply or Activate). When you reopen the dialog box, the zone
configuration is restored.
6. Click OK or Apply to save your changes.
Any zones or zone configurations you have changed are saved in the zone database.
Duplicating a zone configuration
When you duplicate a zone configuration, you make a copy of it in the same zone database. The
first time a zone configuration is duplicated, the duplicate is automatically given the name
<zonesetlabel>_copy. On subsequent duplications, a sequential number is assigned to the zone
configuration name, such as <zonesetlabel>_copy_1, <zonesetlabel>_copy_2, and
<zonesetlabel>_copy_3.
Note that these naming conventions apply to both duplicate and deep duplicate operations.
1. Select Configure > Zoning > Fabric.
The Zoning dialog box displays.
2. Click the Zone DB tab if that tab is not automatically displayed.
3. Select a fabric from the Zoning Scope list.
This identifies the target entity for all subsequent zoning actions and displays the zoning
database for the selected entity.