Brocade Network Advisor IP User Manual v12.1.0 - Manual (Page 629)

Brocade Network Advisor IP User Manual 575
53-1002947-01
Network OS switches in VCS mode
18
Viewing the 802.1x parameter on the Network OS switch
Table 76 describes the parameter that displays on the View Switch dialog box - QoS tab.
Viewing ports in VCS mode
1. Launch the DCB Configuration dialog box using one of the following methods:
• Select Configure > DCB from the menu bar.
• Right-click the DCB switch from the device tree, and select Configure > DCB.
• Right-click the DCB switch from the topology map and select Configure > DCB.
The DCB Configuration dialog box displays, showing the status of all DCB-related hardware and
functions.
2. Select a Network OS switch port in the DCB Products/Ports table and click View.
The View Port dialog box displays, allowing you to view the Network OS switch port parameters.
3. Click one of the following tabs and refer to the appropriate corresponding table for a
description of the feature parameters.
• Port — “Viewing port parameters on the Network OS switch port” on page 575
• QoS — Refer to “Viewing QoS parameters on the Network OS switch port” on page 576.
• FCoE — Refer to “Viewing FCoE parameters on the Network OS switch port” on page 577.
• LLDP-DCBX — Refer to “Viewing LLDP-DCBX parameters on the Network OS switch port” on
page 578.
• 802.1x — “Viewing the 802.1x parameter on the Network OS switch port” on page 578.
Viewing port parameters on the Network OS switch port
Table 77 describes the parameters that displays on the View Port dialog box — Port tab.
TABLE 76 802.1x configuration parameter on VCS switch
Field/Component Description
802.1x Displays the enabled or disabled status of the 802.1x configuration on
the Network OS switch.
TABLE 77 Port parameters on the Network OS switch port
Field/Component Description
Port The status of the port (enabled or disabled).
Profile The port’s profiled status (enabled or disabled). When enabled, the
Interface Mode, L2 Mode, and Default CoS are configured by way of port
profiles.
Interface Mode The port’s configured operating mode. Options include L2 (Layer 2) and
None. is displayed if the port is profiled.
L2 Mode The L2 mode. Supported L2 modes for a port are Access, Trunk, and
Converged. is displayed if the port is profiled.
Default CoS The default Cost of Service (CoS) assigned to the port. The value range is
from COS 0 through COS 7 and the default value is COS 0. is
displayed if the port is profiled.