Brocade Network Advisor IP User Manual v12.1.0 - Manual (Page 131)

Brocade Network Advisor IP User Manual 77
53-1002947-01
IP discovery profiles
4
Adding subnet addresses
To add subnet addresses (IPv4 only), complete the following steps.
1. Select Subnet from the Entry Type list.
FIGURE 22 Include Subnet
2. Enter the IP address in the IP Address field.
3. Enter the subnet mask in the Subnet Mask field.
4. To exclude an address range using the Subnet format, refer to “Excluding subnet addresses”
on page 78.
5. To finish configuring the address ranges, return to “Configuring address ranges” on page 75.
Adding IP addresses
To add an IP address range (IPv4 and IPv6), complete the following steps.
1. Select IP Address from the Entry Type list.
FIGURE 23 Include Address Range
2. Enter the first IP address in the range in the first IP Address field.
3. Enter the last IP address in the range in the second IP Address field.
4. To exclude an address range using the IP Address format, refer to “Excluding IP addresses” on
page 79.
5. To finish configuring the address ranges, return to “Configuring address ranges” on page 75.