Brocade Network Advisor IP User Manual v12.1.0 - Manual (Page 1435)

Brocade Network Advisor IP User Manual 1381
53-1002947-01
CLI Templates
G
TABLE 37 Network OS – Associate MAC to Port Profile
Feature Description CLI Commands
AMPP Associates the MAC to the existing
port profile no port-profile $ activate
no port-profile $ static
$
no port-profile $ static
$
no port-profile $ static
$
port-profile $ activate
port-profile $ static
$
port-profile $ static
$
port-profile $ static
$
TABLE 38 Network OS – Configure CRC Align Errors Monitor
Feature Description CLI Commands
Network OS This template is used to configure
threshold and alert values for CRC
Align Errors (due to FCS Error or
Alignment Error).
Possible values for timebase are
day, hour, minute and none.
Buffer value cannot be more than
average of high plus low threshold.
Supported Values for High and Low
Threshold Action Parameters are
email, raslog, all, and none.
threshold-monitor interface custom type Ethernet area
CRCAlignErrors threshold timebase $
high-threshold $
low-threshold $ buffer
$
threshold-monitor interface custom type Ethernet area
CRCAlignErrors alert above highthresh-action
$ lowthresh-action
$
threshold-monitor interface custom type Ethernet area
CRCAlignErrors alert below highthresh-action
$ lowthresh-action
$
threshold-monitor interface apply custom-monitoring
TABLE 39 Network OS – Configure Extended L2 Access List
Feature Description CLI Commands
ACL This template is used to configure
an extended L2 ACL on Network OS
products running 3.0 or later. mac access-list extended $
deny $ $ any
deny any $ $
deny $ $ $
$
permit $ $ $
$
permit any any