Brocade Network Advisor IP User Manual v12.1.0 - Manual (Page 598)

544 Brocade Network Advisor IP User Manual
53-1002947-01
DCB configuration
18
5. When you have finished configuring the policies, apply the settings to the DCB port.
NOTE
Clicking Cancel when there are pending changes launches a pop-up dialog box.
6. Click OK when you have finished modifying the DCB port parameters.
The Deploy to Ports dialog box displays.
7. Click OK after changing the attributes of the current deployment.
The Deployment Status dialog box launches.
8. Click Start on the Deployment Status dialog box to save the changes to the selected port or
ports.
9. Click Close to close the Deployment Status dialog box.
Editing a LAG
Use the following procedure to change members and policies in a link aggregation group (LAG).
NOTE
Editing a LAG is not supported for Network OS products. You must use the command line interface
to configure a LAG for Network OS products. Refer to the Network OS Command Reference for more
information.
1. Select Configure > DCB.
The DCB Configuration dialog box displays, showing the status of all DCB-related hardware and
functions.
2. Select the link aggregation group (LAG) from the Products/Ports list.
3. Click Edit.
The Edit LAG dialog box displays, as shown in Figure 192 .