Brocade Network Advisor IP User Manual v12.1.0 - Manual (Page 127)

Brocade Network Advisor IP User Manual 73
53-1002947-01
IP discovery profiles
4
IP discovery profiles
NOTE
You cannot configure a discovery profile if you do not have the All IP Products AOR (area of
responsibility) in your user account.
A discovery profile contains the settings you configure when discovery is run. These settings
include address range parameters, ping sweep parameters, SNMP settings, default passwords,
and other settings. The Management application is shipped with a default discovery profile named
“Default”. You can create more than one discovery profile. You can select one discovery profile to
run automatically at startup. After startup, one or more profiles can be run consecutively.
Configuring a discovery profile
NOTE
You cannot configure a discovery profile if you do not have the All IP Products AOR (area of
responsibility) in your user account.
To configure a discovery profile, complete the following steps.
1. Select Discover > IP Products.
The Discover Setup - IP dialog box displays.
2. Click the Profiles tab
FIGURE 20 Profile tab