Sony Multi Interface Shoe Adapter - Manual (Page 999)

999
Settings Relating to Signal Outputs (Output Menu)
Cha
p
te
r 21
DME
S
e
tu
p (DME)
Settings Relating to Signal Outputs (Output
Menu)
To make settings relating to DME output signals, display the DME >Output
menu.
To display the Output menu
In the Engineering Setup menu, select VF4 ‘DME’ and HF3 ‘Output.’
These settings are possible only when the DME is an MVE-9000 or SDI-
interfaced MVE-8000A.
The following functions are available here.
•
Monitor Output: Set the signals output from the four monitor output
connectors.
• Clip Adjust: Adjust the clip level of DME2 output.
Adjusting the Monitor Output
When the MVE-8000A/MVE-9000 is connected through SDI interface, you
can adjust DME2 output video clip level.
Use the following procedure.
1
In the group of the DME >Output menu, press [Clip
Adjust], turning it on.
2
Set the following parameters.
To return the setting to the default value
In the DME >Output menu, press [Default].
Knob Parameter Adjustment Setting values
1 White Clip White clip adjustment 90.00 to 109.02
2 Dark Clip Dark clip adjustment − 6.85 to +10.00
3 Chroma Clip Chroma clip adjustment 90.00 to 113.17