Sony Multi Interface Shoe Adapter - Manual (Page 1000)

C
hap
te
r
2
1
D
M
E Set
u
p
(
D
ME
)
1000
Settings Relating to Signal Outputs (Output Menu)
Setting the Monitor Output
To set the signals output from the four monitor output connectors, use the
following procedure.
Note
This setting is valid when an SDI-interfaced MVE-8000A or an MVE-9000 is
used.
1
In the DME >Output menu, press [Monitor Output].
The Monitor Output menu appears.
2
In the list on the left of the status area, press directly on the monitor output
for which you want to make setting.
3
In the list on the right of the status area, press directly on the signal you
want to output.
4
Press [Set].
The selection is reflected in the monitor output.