Sony Multi Interface Shoe Adapter - Manual (Page 850)

C
h
ap
te
r 1
8
Sy
ste
m
S
e
tu
p
(S
ys
te
m
)
850
Selecting the State After Powering On (Start Up Menu)
Selecting the State After Powering On (Start
Up Menu)
Set the initial state of the devices when the system is powered on.
For each device, you can select Resume mode or Custom mode.
Resume mode
This resumes the setting state at the previous power-off operation. This setting
is only available for the switcher processor and panel.
Custom mode
This uses the settings saved in non-volatile memory or ROM within the device.
In this mode, there are Setup and Initial Status settings which can be set
separately.
•
Setup mode: Select the setup state to be used after powering on from the
following.
User: Start up using the user data previously saved with [Setup Define].
Factory: Start up with the factory default settings.
• Initial status mode: Select the state of each device after powering on
(excluding the settings to which “setup” applies).
User: Start up using the user data previously saved with [Initial Status
Define]. For the control panel, this applies to the key bus delegation
buttons only.
Factory: Start up with the factory default settings.
For details of saving and recalling setup data, see “Saving and Recalling Setup
Data” (page 851) and the appendix “Data Saved by [Setup Define] and [Initial
Setup Define]” (Volume 2).
Autoload function
Switch on or off the function to automatically load predetermined register data
or frame memory image data at power on. Set the data to be read in the File
menu.