Sony Multi Interface Shoe Adapter User Manual
Page 697
697
Snapshot Operations in the Menus
Cha
The selected region name appears in the upper part of the list.
4
Using any of the following methods, select the register.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knobs.
• To select all registers, press [ALL].
5
In the
apply, turning them on.
Carry out the following procedures for each of the attributes.
To apply the cross-point hold attributes
Note
Applying the key disable attribute (so the key state is not reflected) to cross-
point hold requires a setting in setup.
For details, see “Selecting the Bank to
Make the Settings” in Chapter 20 (Volume 3)
.
1
Press [XPT Hold].
The Snapshot>Attribute>Xpt Hold menu appears. The status area shows a
list of the currently selected regions and bus names.
2
Using any of the following methods, select the register.
• Press directly on the list in the status area. To select one or more buses,
press [Plural] and then select buses.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knobs.
a) Appears when the region is RTR.
b) Appears when the region is other than RTR.
• To select all registers, press [ALL].
3
When the region is set to RTR (Router) only, press [RTR Level].
Knob Parameter
Adjustment
Setting
values
1
Register
Register number
1 to 99
2
Num
Select number of registers
1 to 99
Knob Parameter
Adjustment
Setting
values
2
Destination
a)
Destination selection
1 to 128
3
Bus
b)
Bus name selection
–