Sony Multi Interface Shoe Adapter - Manual (Page 914)

Ch
apt
er 19
C
o
nt
rol P
ane
l
S
e
tup (P
an
el)
914
Auxiliary Bus Control Block Settings (Aux Assign Menu)
M/E1 Utility, P/P Utility, Frame Memory Source1 and 2, Edit Preview, DSK1 to 4 Fill/
Source, M/E-1 Key 1 to 4 Fill/Source, M/E-1 EXT DME, P/P EXT DME, and CCR 1
and 2
• For a button for which you want to disable operation, press [Inhibit].
2
Press [Set] to confirm the selection.
To set the AUX delegation button shift operation
To set the operation mode of the rightmost button in the row of AUX
delegation buttons, select one of the following in the group of
the Panel >Aux Assign menu.
Hold: Acts as a shift button, and the shifted version of the AUX delegation
buttons is enabled while the button is held down.
Lock: Acts as a shift button, and pressing the button toggles between the
shifted version and the unshifted version of the AUX delegation buttons.
Off: Acts as an AUX delegation button. In a 16-button system it acts as button
number 16, in a 24-button system as button number 24, and in a 32-button
system as button number 32.
Using the Auxiliary Bus Control Block for Router
Control
To make router control settings, display the Setup >Panel >Aux Assign >RTR
Mode Setting menu.
Note
This setting is disabled for the CCP-9000/9000A.
To display the RTR Mode Setting menu
1
In the Engineering Setup menu, select VF2 ‘Panel’ and HF3 ‘Aux Assign.’
The Aux Assign menu appears.
2
Press [RTR Mode Setting].
The RTR Mode Setting menu appears. The left of the status area shows the
destination number assignment status and source table, and the right side
lists the destinations that can be assigned.
Assigning a destination to a destination selection button
In the Panel >Aux Assign >RTR Mode Setting menu, use the following
procedure.