Sony Multi Interface Shoe Adapter User Manual
Page 928
Ch
apt
928
Setting Button Assignments (Prefs/Utility Menu)
a) For the safe title on/off commands (from ME1 PGM1 ST-ME1 PGM4 ST to AUX1 ST-AUX48
ST), the name of the assigned output signal is shown.
Assigning a menu shortcut to a memory recall button
1
Referring to the procedure up to step
3
on
, select [Menu Shortcut].
The memory recall buttons in the utility/shotbox control block flash
orange.
2
Using any of the following methods, display the menu to which you want
to make a shortcut.
• In the menu control block, press the relevant top menu selection button,
then select VF and HF.
• Press the menu page number button in the upper left corner of the menu
screen, then enter a menu number from the numeric keypad window.
• Press a particular control panel button twice in rapid succession.
3
In the utility/shotbox control block, select the bank, and press the button to
which you want to assign the shortcut.
The menu screen goes back to the Prefs/Utility >Utility Module Assign
menu, and the selection is reflected in the status area.
The buttons in the utility/shotbox control block flash.
4
Repeat steps
2
and
3
as required, to assign all desired menu shortcuts to
the buttons in the utility/shotbox control block.
To abandon the process of menu shortcut assignment
In the Prefs/Utility >Utility Module Assign menu, press [Menu Shortcut].
This exits the menu shortcut assignment mode.
DME Graphic
DME graphics on/off (Applies to
graphics for channel selected in device
control block)
On Off
Plug-In Editor Enbl
Enable/disable operation from an
editing keyboard
Enabled
Disabled
Inhibit Set
Inhibit cross-point button
Can be set only
while pressed (lit)
When the function
is assigned
Inhibit All Clear
Clear all cross-point button inhibit
settings
Can be set only
while pressed (lit)
When the function
is assigned
Command name
a)
Function
Button status
Lit green
Lit orange