Sony Multi Interface Shoe Adapter - Manual (Page 194)

194
Key Setting Operations With the Key Control Block
Chap
te
r
4
K
e
y
s
Applying a DME Effect to a Key
Note
For one M/E bank, DME effects (including DME wipes) can be used in two
places.
Assigning a DME to a key
1
In the key control block, press the delegation buttons [M/E1] and [KEY1].
2
Using the DME channel selection buttons, select the DME channel
(DME1, DME2) for applying the effect.
The lit colors of the [DME1] and [DME2] buttons indicate the DME
assignment.
Lit green: Shows the DME assigned to the currently selected key.
Lit amber: Shows the DME assigned to a key other than the currently
selected key.
Off: DME is not assigned.
To select a DME being used by another keyer
Press [Override], turning it on, then select the DME channel.
The later selection is valid, and the button lights green.
You can check the DME operating status in the Status menu (see page 334) .
Selecting the video signal for the DME assigned to a key
For the operating procedure, see“Selecting the video signal for a DME
assigned to a key” (page 184).
Assigning the DME output signal to a monitor signal
1
Holding down the output destination specification button [MON] in the
key control block, use the DME channel selection buttons to select the
DME channel (DME1 or DME2) you want to use.
The selected DME output is assigned to DME MON V and DME MON K.
2
To check the DME assignment status, hold down just the [MON] button.
While it is held down, the lit color of the [DME1] and [DME2] buttons
shows the key assignment status.
Lit green: Shows the DME currently being monitored.