Sony Multi Interface Shoe Adapter User Manual
Page 433
433
Three-Dimensional Transformation Operations
Chapt
3
Turn [Graphic] on.
The system enters graphics display mode, enabling graphics to be
displayed in the monitor screen.
4
Turn on the buttons of the graphics you want to show.
To show axes:
Turn [Axis] on.
To show axis names:
Turn [Axis Name] on.
To show the channel ID:
Turn [Ch ID] on.
To show a wire frame:
Turn [Wire Frame] on.
To show the grid:
Turn [Grid] on.
To show the flex shadow axis:
Turn [Flex Shadow Axis] on.
The selected graphics appear in the monitor screen.
Note
The flex shadow axis function is not supported on the MVE-8000A and
MKS-6470.
5
If you want to shrink the graphics display to show the range not displayed
on a normal monitor, turn [Scale] on and set the following parameters.
As the value of the setting grows, the monitor shrinks further toward the
center point.
6
To automatically erase the graphic display while the keyframes are
executing, press [Auto Erase], turning it on, and then set the following
parameter.
Outputting graphics to the monitor output connector
In the Graphic menu, press [Monitor Out] to turn it on.
Graphics are displayed on the device connected to the monitor output
connector.
Knob
Parameter
Adjustment
Setting values
1
Scale
Degree to which the graphics
display is shrunk
0.00 to 100.00
Knob
Parameter
Adjustment
Setting values
1
Recover Time
Time until graphic display
appears again after keyframe
execution
0 to 300 (frames)