Sony Multi Interface Shoe Adapter - Manual (Page 528)

Cha
p
te
r 11
DME
O
per
at
ion
s
528
DME Special Effect Operations
2
To make transition settings, press [Transition] and set the following
parameters.
3
To make wave settings for melting part, press [Border] and set the
following parameters.
a) Set when Lock is on.
b) Set when Lock is off.
c) Setting for SD 4:3, SD 16:9
d) Setting for HD 4:3, HD 16:9
To stop the waves in the melting part
Press [Lock], turning it on.
With each press, the waves alternately stop and start moving again.
To select the shape of the part beginning to melt
Press [Form] and set the following parameter.
a) 1 (SINE): Sine wave
2 (PARABOLA): Parabola wave
3 (TRIANGLE): Triangular wave
4 (RECTANGLE): Rectangular wave
5 (CIRCLE): Circular wave
6 (CUBIC): Cubic wave
7 (MELT1): Melting wave 1
8 (MELT2): Melting wave 2
To make the melting part stardust
1
Press [Pixel], turning it on.
Knob Parameter Adjustment Setting values
1 Transition Degree of transition 0.00 to 100.00
2 Curve Degree to which image stretches 0.00 to 100.00
3 Random Degree of jaggies at melted part 0.00 to 100.00
Knob Parameter Adjustment Setting values
1 Amp Amplitude of waves 0.00 to 100.00
2 Freq Frequency of waves 0.00 to 100.00
3
Offset
a) Amount of wave phase offset
–16.000 to +16.000
c)
–64.000 to +64.000
d)
4
Speed
b) Direction and speed of waves –100.00 to +100.00
5 Slant Slant of border –100.00 to +100.00
Knob Parameter Adjustment Setting values
1 Form Waveform
1 to 8
a)