Sony Multi Interface Shoe Adapter - Manual (Page 575)

575
Global Effect Operations
Chapt
er
11
DME Ope
ra
tions
Shadow Settings
The effect uses two successive channels. You can adjust the position and
density of the shadow with respect to the image, and the color of the shadow.
The channel with the largest number (for example, Ch2 in the case of Ch1 and
Ch2) becomes the shadow.
Note
When the Combiner function is off, the shadow effect cannot be used.
Applying the Drop Shadow effect
The Shadow menu allows you to apply the Drop Shadow effect. To access the
Shadow menu, in the Global Effect>Ch1 - Ch2 menu select HF3 ‘Shadow.’
Depending on the selected combiner channels, the valid buttons differ as
follows.
Taking Ch1 Shadow as an example, the following explains the procedure for
applying the Drop Shadow effect.
1
Press [Ch1 Shadow], turning it on.
The Drop Shadow effect is enabled, and channel 2 becomes the channel for
the shadow to the image. You can adjust the position and density of the
shadow with the knobs.
Note
The flex shadow function cannot be enabled when Drop Shadow is
enabled.
However, the flex shadow function is not supported on the MVE-8000A
and MKS-6470.
2
Set the parameters.
a) Setting for SD 4:3, SD 16:9
b) Setting for HD 4:3, HD 16:9
3
In the group, select the shadow source signal.
Knob Parameter Adjustment Setting values
1 Position H Horizontal shadow position
–8.00 to +8.00
a)
–32.00 to +32.00
b)
2 Position V Vertical shadow position
–8.00 to +8.00
a)
–32.00 to +32.00
b)
3 Density Density of shadow 0.00 to 100.00