Sony Multi Interface Shoe Adapter - Manual (Page 611)

611
Control of VTRs, Extended VTRs, and Disk Recorders
Chap
te
r 1
2
Ex
te
rnal
De
v
ic
e
s
6
Set the start point as a timecode value.
7
Press [Enter].
The new start point setting is reflected in the status area.
8
To set the stop point, in the group press the [Set] button.
A timecode window appears.
If you do not want to set the stop point, skip to step
11 .
9
Set the stop point as a timecode value.
10
Press [Enter].
The new stop point setting is reflected in the status area.
11
To set the variable speed, in the group, carry out either
of the following.
• Press [Fit].
Without setting a speed value, this automatically carries out playback
according to automatically calculated values for the duration and
keyframe duration to fit the set start point and stop point.
• Press the [Set] button, and adjust the parameter with the knob.
a) The setting range of the variable speed depends on the type of connected device.
The new variable speed setting is reflected in the status area.
Repeat steps 2 to 11 as required for other devices.
To carry out start point and stop point settings and cueing up
operations in the device control block
With the following buttons in the device control block, you can set the start
point or stop point of a keyframe point on the timeline, or carry out a cueing up
operation.
Notes
• When using the optional device control block (trackball module), check that
the [MENU] button in the block is lit amber. If it is not lit, press it, turning it
on.
• When using the device control block (search dial), check that the
[TIMELINE] is lit amber.
Knob Parameter Setting Setting values
2 Variable Variable speed
–100 to +200
a)