Setting the signal format (format menu), Setting the signal format – Sony Multi Interface Shoe Adapter User Manual
Page 844

C
844
Setting the Signal Format (Format Menu)
Setting the Signal Format (Format Menu)
To set the format, that is, the frame frequency and number of scan lines handled
by each device, use the System >Format menu.
To display the Format menu
In the Engineering Setup menu, select VF1 ‘System’ and HF3 ‘Format.’
Note
After changing any of the following settings, be sure to press [Execute] (or [FC
Format Execute] for changing the format converter signal format) to save the
new values. If you want to cancel the settings and return to the original state,
press [Clear] without pressing [Execute] or [FC Format Execute]. When you
press [Execute], some data is lost (such as frame memory images). If you press
[FC Format Execute], memory is not initialized, and this data is not lost.
Setting the Signal Format
Specify the signal format to be handled by the devices.
The combinations of signal formats that can be selected are as follows.
To use the MVS-6000 with multi-format support requires the optional BZS-
6540M Switcher Upgrade Software.
The following software options are also required depending on the number of
M/E banks.
To use the software, you are required to input an install key.
System
Field frequency
Effective number of scan lines
HD system
50
1080i
59.94
50
720P
59.94
SD system
59.94
480i
50
576i
Product name
Model No.
System
Mix/Effect Upgrade Software
BZS-6550M
2M/E system
Additional M/E Software
BZS-6300
2M/E system