Sony Multi Interface Shoe Adapter User Manual
Page 263
263
Creating User Programmable DME Patterns
Chap
• During the course of a transition, there is a “dead zone” corresponding to the
intermediate point of the whole effect
(see following figure),
during which
the image does not change. Therefore, it is necessary to create the effect so
that the image in the intermediate part of the transition is the keyframe for
the mid-point of the whole effect. The range of this “dead zone” corresponds
to the central one-third of the range of the transition indicator. This also
applies to an auto transition.
• Create the last keyframe for each channel as follows.
Channel 1:
since the priority is low, it will not be visible on the screen, so
no particular restrictions apply.
Channel 2:
create the image full-size.
• In the
select [P In P].
A
B
C
Keyframe effect
First keyframe
Last keyframe
Mid-point of effect
Change in image through transition
Image at point C
appears
Image at point B
appears
(dead zone)
Image at point A
appears
Transition indicator
Fader lever