Sony Multi Interface Shoe Adapter User Manual
Page 600
600
Control of VTRs, Extended VTRs, and Disk Recorders
Ch
apt
5
When using the MKS-8031TB trackball module, press the [DEV] button
in the device control block, turning it on.
Note
Check that the [MENU] button is not lit. If it is lit, press to turn it off.
6
With the device selection buttons in the device control block, select the
VTR, Extended VTR, or disk recorder for which you want to make the
setting.
You can select more than one button.
The first button pressed lights green to indicate the reference region, and
the subsequent buttons light amber.
7
Set the start point.
• Using the [START TC] button:
Play the VTR, Extended VTR or disk recorder by control from the
device control block. Find the desired start point, and press the [START
TC] button at that position.
If using the [START TC] button, each time you press the button the start
point timecode is overwritten.
• Using the [SET START TC]:
Press the [SET START TC] button in the optional device control block
(search dial module, option).
The display in the numeric keypad control block shows “START TC”.
Enter the desired timecode from the numeric keypad control block, and
press [ENTER].
For details of timecode entry, see “Setting the start point and stop point
with the [SET XX] buttons” (page 602).
• Setting with the Cueup & Play menu:
For details of settings in the Cueup & Play menu, see “Setting the start
point, stop point, and start delay time in a menu” (page 604).
8
Set the stop point or duration.
When two of the start point, stop point and duration are set, the remaining
one is automatically determined. For example, if you set the stop point in
the following procedure, you do not need to enter the value of the duration.
• Using the [STOP TC] button:
Play the VTR, Extended VTR or disk recorder by control from the
device control block. Find the desired stop point, and press the [STOP
TC] button at that point.