Sony Multi Interface Shoe Adapter - Manual (Page 355)

355
Color Corrector Functions
Chap
te
r 9
Color
Cor
rect
o
r
To return the parameters to their default settings
In the group, press [Unity].
Masking a part of luminance processing
In the group, press [Mask1] or [Mask2], turning it on, then
carry out the same procedure as in
“Masking a part of the primary color
correction” (page 348).
Spot Color Adjustment
You can change the color of a specified color region to a different color,
without affecting other regions. You can also mask part of such a region.
Then for the region other than the region whose color you have changed, you
can make the following corrections.
• Video signal overall gain adjustment
• Y signal gain adjustment
• Y signal offset adjustment
• C signal gain adjustment
• C signal hue adjustment
Adjusting the color of the specified region (key)
1
In the CCR menu, press VF1 ‘CCR1’ and HF6 ‘Spot CCR/Output.’
The Spot CCR/Output menu appears.
2
In the group, press [Spot CCR], turning it on.
3
In the group, press [Sample Mark], turning it on.
Note
When [Sample Mark] is on, the effects of color adjustment outside the
region of spot color adjustment
(see page 357) and output video processing
(see page 357) are temporarily disabled.
Turning [Sample Mark] off restores the former state.
Knob Parameter Adjustment Setting values
1 Luminance Luminance –100.00 to +100.00
2 C Gain Chrominance signal gain 0.00 to 200.00
3 Hue Delay Hue delay –180.00 to +180.00