Sony Multi Interface Shoe Adapter - Manual (Page 957)

957
Settings for Switcher Configuration (Config Menu)
Cha
p
te
r 20
Swi
tc
h
e
r S
e
tup (Swit
c
her
)
To set 4:3 video material to have side flags applied automatically
You can make a setting so that when a signal with aspect ratio set to 4:3 is
selected in the cross-point control block, side flags are automatically applied.
To do so, in the Switcher >Config >Side Flags menu press [Auto Side Flags].
Pressing this button toggles the setting on and off.
This setting applies to all of the M/E and PGM/PST banks.
To set to crop to 4:3 when a DME wipe is executed
When side flags are enabled, you can automatically crop an image as set to be
a 4:3 image when executing a DME wipe.
To do so, in the Switcher >Config >Side Flags menu press [Auto Crop].
Pressing this button toggles the setting on and off.
This setting applies to all of the M/E and PGM/PST banks.
Adjusting the width of the side flags
You can adjust the width of the side flags.
1
In the Switcher >Config >Side Flags menu, press [Width].
2
Adjust the following parameters.
Displaying the menu for enabling/disabling the side flags
In the Switcher >Config >Side Flags menu, press [Misc >Enbl >Setup Flags].
Displaying the menu for assigning the side flags on/off function
to a cross-point button
In the Switcher >Config >Side Flags menu, press [Side Flags Button Assign].
Knob Parameter Adjustment Setting values
3 Left Width of left side flag –100.00 to +100.00
4 Right Width of right side flag –100.00 to +100.00
5 All Width of both side flags Left value shown