Sony Multi Interface Shoe Adapter - Manual (Page 916)

Ch
apt
er 19
C
o
nt
rol P
ane
l
S
e
tup (P
an
el)
916
Auxiliary Bus Control Block Settings (Aux Assign Menu)
Setting the source table
1
In the Panel >Aux Assign >RTR Mode Setting menu, press [Source Table
Assign].
The Source Table Assign menu appears.
2
In the group, select the source table you want to
manipulate.
3
Press [Table Assign].
The Table Assign menu appears.
The left of the status area lists the button numbers and set sources, and the
right side lists the source that can be assigned.
4
Using any of the following methods, select a source selection button and
the source you want to assign.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knobs.
• For a button whose operation you want to disable, press [Inhibit].
5
Press [Source Set] to confirm the selection.
To set the shift operation of the source selection buttons
To set the operation mode of the rightmost button in the source selection button
row with different destinations assigned to the 1st and 2nd rows, select the
source table in the Source Table Assign menu, then in the
group select one of the following.
Hold: Acts as a shift button, and the shifted source selection buttons are
enabled while the button is held down.
Lock: Acts as a shift button, and pressing the button toggles between the
shifted and unshifted states of the source selection buttons.
Off: Acts as a cross-point button, that is, button number 16 on a 16-button
system, button number 24 on a 24-button system, and button number 32 on
a 32-button system.
Knob Parameter Adjustment Setting values
1 Source No Source selection button selection 1 to 128
2 No Source selection in S-Bus space 1 to 1024