[AUTO TRANS] button, or operate the fader lever.
To execute a transition by pressing the [AUTO TRANS] button, first
set the transition rate (specified as the duration of the transition).
(

See “Setting the Transition Rate” (page 130).)

When you have selected a wipe or DME wipe as the transition type,
you can also set the transition range.

(See “Pattern Limit” (page 132).)

For an instantaneous transition:

Press the [CUT] button.

For details, see “Executing a Transition” (page 129).

Transition linked to the audio mixer

If the video signal selected in the background B row is linked to the audio mixer
in setup, then the audio mixer sound changes with the transition. That is,
pressing the [AUTO TRANS] button gives a cross fade, and pressing the
[CUT] button gives an instantaneous sound switch.

For details of setup, see “Cross-Point Settings (Xpt Assign Menu)” in Chapter
19 (Volume 3).

Notes

• The audio mixer is not linked to a snapshot or key frame transition.
• The audio mixer is not linked to a transition using the fader lever.
• If the bus-fixed mode

(see page 138)

is selected in the setup menu, and the

fader lever is in the lowest position, there is a cross fade from the audio
selected on the B row to the audio selected on the A row.

• The audio mixer is not linked to a key transition.
• In the following cases, the audio and video may be out of sync.

– When carrying out a cross fade in some DME wipes (for example, “picture

in picture”)

– When executing a preset color mix in two-stroke mode

• For details of audio mixers that can be used, Sony service or sales

representative.