Sony Multi Interface Shoe Adapter - Manual (Page 242)

242
Basic Procedure for DME Wipe Settings
Ch
apt
er
6
DME
Wip
e
s
Basic Procedure for DME Wipe Settings
You carry out DME wipe setting operations principally using the DME Wipe
menu for each bank.
This section describes the basic procedures for DME wipe settings, taking the
M/E-1 >DME Wipe menu as an example.
For details of independent key transition DME wipe settings, see “DME Wipe
Settings for Independent Key Transitions” (page 252).
DME Wipe Settings Menu
Accessing the DME Wipe menu
To access the M/E-1 >DME Wipe menu, use either of the following operations.
• In the menu control block, select the top menu selection button [M/E 1], and
press VF6 ‘DME Wipe.’
• In the transition control block of the M/E-1 bank, press the transition type
selection button [DME] twice in rapid succession.
Either of the above operations displays the M/E-1 >DME Wipe menu.
DME Wipe Pattern Selection
Selecting a DME wipe pattern by a menu operation
1
In the M/E-1 >DME Wipe menu, select HF1 ‘1ch’ for one-channel mode
and select HF2 ‘2ch’ for two-channel mode.
2
Select the DME wipe pattern group with one of the following buttons.
• Slide/Squeeze: slide and squeeze
• Door: door
• Frame I/O: frame in-out
• 2D Trans/3D Trans: 2D trans and 3D trans
• Mosaic/Defocus: mosaic and defocus
• Brick: brick