beautypg.com

Selecting outputs and target frame memory – Sony Multi Interface Shoe Adapter User Manual

Page 274

background image

274

Still Image Operations

Chapt

er

7

F

rame

Memo

ry

When using the signal on frame memory source bus 1 or 2 for the input image,
select the signal as described below.

For the method of using a color matte signal, see “Freezing an image and
writing it to memory” (page 275).

Selecting the signal on a frame memory source bus

As an example, to select a signal on frame memory source bus 1, use the
following procedure.

1

Using the bank selection buttons in the auxiliary bus control block, select
the desired bank.

2

In the auxiliary bus control block, press the AUX delegation button to
which frame memory source bus 1 is allocated, turning it on.

For allocation of buses to the AUX delegation buttons, see “Assigning a
Bus to an AUX Delegation Button” in Chapter 19 (Volume 3).

3

In the key row of the bank selected in step

1

, select the signal to be used

for the input image.

Selecting Outputs and Target Frame Memory

Selecting outputs (FM) and target frame memory

The following description applies to the case of settings for FM1&2, but the
procedures are similar for the other cases.

1

In the Frame Memory menu, press one of VF1 to VF4, and select the
required HF menu.

The current status of frame memory appears.

(See page 270).

2

From the pair selection buttons, press the buttons corresponding to FM1
and FM2.

This assigns the signals to FM1 and FM2.
To the right of the target FM selection buttons, the FM1 and FM2 output
status appears

(see page 271)

.

3

If required, press [Pair], to select the FM operation mode (pair mode).

On:

Operate on FM1(3, 5, 7) and FM2(4, 6, 8) as a pair.