Wind settings, Disabling the keyframe strobe afterimage, Setting a combine process – Sony Multi Interface Shoe Adapter User Manual
Page 543: Applying the wind effect
543
DME Special Effect Operations
Chapt
a) The way in which the afterimage disappears is affected by both the Decay and KF Strobe
Dust parameter adjustments for the keyframe strobe.
Disabling the keyframe strobe afterimage
Press [KF Strobe Disable], turning it on.
If you turn this function on when creating a keyframe, even as the effect passes
a keyframe, no afterimage remains.
Setting a combine process
Select whether to add the Keyframe Strobe effect before or after the combine.
Notes
• The combine process function is not supported on the MVE-8000A and
MKS-6470.
• When you change the selection in the
afterimages which had been added up to then disappear.
• When you do not combine images, the Keyframe Strobe effect only is
applied, regardless of the selection in the
Select one of the following in the
Combine –> KF STRB:
Add the Keyframe Strobe effect after the combine.
As parameters, the data for the channel with the lowest number among the
channels being combined is enabled.
KF STRB –> Combine:
Add the Keyframe Strobe effect before the combine.
Parameters can be set independently for each channel.
Wind Settings
Notes
• The wind function is not supported on the MVE-8000A and MKS-6470.
• When wind is turned on, any of the following effects that are on are turned
off.
– Trail
– Motion decay
– Keyframe strobe
Applying the wind effect
1
In the DME menu, select VF5 ‘Light/Trail’ and HF5 ‘Wind.’
The Wind menu appears.