Making settings required to use the software – Sony Multi Interface Shoe Adapter User Manual
Page 858

C
858
Installation and Device Setup (Install/Unit Config Menu)
7
Repeat steps
3
to
6
, to confirm all software to be installed.
8
Press [Execute].
A confirmation message appears.
9
Press [Yes].
This carries out the installation, and when it completes normally, the
“Install” box shows “OK.”
Making Settings Required to Use the Software
To use the software listed below, you are required to enter an install key which
validates the software. (If the software has been factory installed, the install key
is not required.)
For the method of obtaining an install key, contact your Sony representative.
To obtain a key, you may be required to submit the unique device ID of the
switcher you are using. You can check the unique device ID in the Install/Unit
Config menu of the switcher, using the following procedure.
a) This can be used only with a CCP-9000A series control panel.
b) This can be used only on the MVE-8000A.
To display the unique device ID
1
In the System >Install/Unit Config menu, use either of the following
methods to select the device for which you want to register the license.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
2
Press [License].
The License menu appears as follows.
BZS-6250
Simple P/P Software
BZDM-9050
Texture Lighting Software (for MVE-9000)
BZS-8050
Editing Control Software
a)
BZS-6420
Color Corrector Software
BZS-6300
Additional M/E Software
BZS-6540M
Switcher Upgrade Software
BZS-6550M
Switcher Upgrade Software
BZDM-8560
DME Upgrade Software
b)