Sony Multi Interface Shoe Adapter - Manual (Page 536)

Cha
p
te
r 11
DME
O
per
at
ion
s
536
DME Special Effect Operations
Applying the Trail effect
1
In the DME menu, select VF5 ‘Light/Trail’ and HF2 ‘Trail.’
The Trail menu appears.
2
Press [Trail], turning it on.
The Trail effect is enabled. You can adjust the parameters with the knobs.
3
Set the parameters.
a) 0.00 is no trail. At 100.00, the trail does not disappear.
4
To erase the trail, press [Trail Eraser], turning it on.
Switching the priority between the current image and trail
superimposed
In the group, select the method of superimposition.
Over: Current image is on top.
Under: Trail is on top.
Selecting the source to create a trail
In the group, select the source to create a trail.
Notes
• “Rainbow,” “Mix Color,” and “Ext Video” are not supported on the MVE-
8000A and MKS-6470.
• “Mix Color”or “Ext Video” can only be applied to one of the background
(see page 563) , flex shadow (see page 466) , trail, and wind (see page 543)
effects.
If you select “Mix Color” or “Ext Video” in one of these settings, a selection
of “Mix Color” or “Ext Video” in any of the other effects is disabled, and
“Flat Color” is selected in its place.
• When executing combining four channels of DME images, “Mix Color” and
“Ext Video” in the flex shadow and background effects cannot be selected.
Knob Parameter Adjustment Setting values
1 Decay Degree to which the trail is left
0.00 to 100.00
a)
2 Interval Freeze interval 1 to 255 (frames)
3 Live Proportion of the interval
between two successive freeze
images for which the video is
run 0.00 to 100.00