Sony Multi Interface Shoe Adapter User Manual
Page 694
Chap
694
Snapshot Operations From the Numeric Keypad Control Block
“Assigning a Region to a Region Selection Button in the Numeric Keypad
Control Block” in Chpater 19 (Volume 3).)
It is not possible to select [MASTR] and other regions simultaneously. If
selected simultaneously, the master snapshot takes precedence.
The first pressed button lights green as the reference region, and
subsequently pressed buttons light amber.
Pressing one of the amber-lit buttons, while holding down [SNAPSHOT],
turns the button green to indicate its corresponding region as the new
reference region.
For details of the precedence order for becoming the reference region, see
“Reference region” (page 620).
The display shows the name of the reference region and the number of the
register previously recalled for that region.
3
Enter the desired register number from the numeric keypad.
See step
5
(page 692) in “Saving a snapshot from the numeric keypad
The entered register number appears in the display.
4
To apply temporary attributes, press the following buttons, turning them
on.
a) Enabled by a setup setting (page 697).
For the setup setting, see “Operation Settings (Operation Menu)” in
Chapter 19 (Volume 3).
For details of temporary attributes and available attributes, see “Snapshot
Attributes” (page 689).
Notes
• The cross-point hold and key disable settings are maintained until you
next press the [XPT HOLD] button.
Control block
Temporary
attribute to apply
Button
Cross-point control
block
A/B bus cross-point
hold
[XPT HOLD] button in the
background A/B bus
Key cross-point hold
[XPT HOLD] button
a)
Numeric keypad
control block
Effect dissolve
[+/–/EFF DISS] button
Auto transition
[CLR/AUTO TRANS] button