Sony Multi Interface Shoe Adapter - Manual (Page 159)

159
Key Setting Operations Using Menus
C
h
ap
te
r 4
K
e
ys
Key Type Setting
Setting the key type in a menu
1
In the M/E-1 >Key1 menu, select HF1 ‘Type.’
The Type menu appears.
2
In the group, select the key type.
Luminance: luminance key
Linear: linear key
Chroma: chroma key
Color Vector: color vector key
Key Wipe Pattern: key wipe pattern key
For the selected key type, you can now set the parameters.
For an overview of the key types, see “Key Types” (page 151).
3
Carry out the following settings as required, depending on the key type
selected in step
2 .
To enable clean mode (see page 152) for a luminance key, linear key or
color vector key: Select [Clean Mode] so that it is set on.
When clean mode is enabled, key fill is added to the background
without cutting out with key source.
When chroma key is selected: Select [Chroma Adjust] to access the
Chroma Adjust menu (see page 164) , and make the required settings.
When a key wipe pattern key is selected: In the M/E-1 >Key1 >
Transition >Wipe Adjust menu (see page 223) , carry out pattern
selection and modifier setting, then return to the M/E-1 >Key1 >Type
menu.
Note
For a wipe pattern selected for a key wipe pattern key, the [Edge] and
[Direction] modifier settings are not available.
4
Set the parameters.
• When a luminance key or linear key is selected
Knob Parameter Adjustment Setting values
1 Clip Reference level for generating the
key signal +109.59 to –7.31
2 Gain Key sensitivity –100.00 to +100.00