Sony Multi Interface Shoe Adapter - Manual (Page 111)

111
Signal Selection
Cha
p
te
r 3
Sig
nal Se
lec
tion and
T
ra
n
s
iti
ons
To clear a cross-point button operation inhibit setting
Hold down the button to which “Inhibit Set” is assigned, and press the button
whose operation is inhibited (flashing amber).
This clears the operation inhibit setting for the button you pressed.
To clear all operation inhibit settings
Press the button to which “Inhibit Set” is assigned and the button to which
“Inhibit All Clear” is assigned simultaneously.
Selection of signals linked with the audio mixer
When you select a signal in a switcher bank background A row or AUX bus
control block which is set to be linked with the audio mixer, the program output
of the audio mixer follows the signal selection.
For details of the setting, see “Cross-Point Settings (Xpt Assign menu)” in
Chapter 19 (Volume 3).
Notes
• For details of audio mixers that can be connected, contact your Sony service
or sales representative.
• When the signal is switched with a snapshot, keyframe, and so on, the audio
mixer is not linked.
• When bus fixed mode is selected in setup (see page 138) , the audio mixer
program output is linked to the bus output as the background.
Signal Name Display
You can attach a name (source name) to each signal assigned to a cross-point
button, with a maximum of 16 characters.
• The source name displays in the cross-point control block and auxiliary bus
control block show the source names of the video signals assigned to
numbers 1 to 12 (or 11).
• To display the source names for shifted numbers (13 to 24 or 12 to 22), press
the [SHIFT] button to the right of the key row delegation buttons.
• To display the source names of the key signals assigned to button numbers,
hold down one of the key delegation buttons [KEY1] to [KEY4] or [DSK1]
to [DSK4] buttons or, for the auxiliary bus control block, hold down the
[KEY] button.