Executing a macro assigned to a fader lever – Sony Multi Interface Shoe Adapter User Manual
Page 761
761
Macro Attachment Assigning
Chap
To disable macro attachment settings
Press the [MCRO ATTCH ENBL] button assigned to a utility/shotbox control
block button or user preference button, turning it off.
In this state, pressing a button for which a macro attachment is set does not
execute the macro.
Executing a macro assigned to a fader lever
1
Press the [MCRO ATTCH ENBL] button assigned to a utility/shotbox
control block button or user preference button, turning it on.
2
Move the fader lever from the start position to the end position.
When the fader lever passes the position at which the macro attachment is
set, the macro register is recalled, and the macro is executed.
Notes
• Unless you move the fader lever to the end position (completing the travel),
it is not possible to execute the macro again.
• When the preset color mix stroke mode is Normal
(see “Settings Relating to
Video Switching (Transition Menu)” in Chapter 20 (Volume 3))
, the first
lever operation executes the macro, but the second lever operation does not.
• During macro execution, it is not possible to execute another macro.
• Individual events stored in a macro are executed according to the settings in
setup. If you change the settings in setup, a saved macro may not have the
expected effect.
• During macro execution, if you switch the control panel to macro editing
mode, the macro being executed stops.
• During macro editing, even if you operate a fader lever with a macro
attachment set, the macro is not executed.
To disable a macro attachment setting
Press the [MCRO ATTCH ENBL] button assigned to a utility/shotbox control
block button or user preference button, turning it off.
In this state, operating a fader lever with a macro attachment set does not
execute the macro.