Selecting the background transition flip-flop mode, Setting the split fader to be enabled or disabled, Enabling or disabling the fade-to-black function – Sony Multi Interface Shoe Adapter User Manual
Page 972
Chapt
972
Settings Relating to Video Switching (Transition Menu)
Normal:
Switching the [TRANS PVW] button on or off switches between the
transition preview mode and the normal mode.
Selecting the transition mode of the independent key transition
control block
To select the key transition mode, select either of the following in the
Same:
The transition settings for the On and Off directions are the same.
Independ:
The transition settings for the On and Off directions can be set
separately.
Selecting the background transition flip-flop mode
In the Transition menu, press [Bus Toggle], to switch between on and off.
On:
Flip-flop mode
Off:
Bus fixed mode
For more details, see “Fader Lever Operation in Bus Fixed Mode” in Chapter
3 (Volume 1).
Setting the split fader to be enabled or disabled
In the Transition menu, press [Split Fader] to switch between Enable and
Disable. This setting is only valid when using a simple transition module with
Bus Toggle set to Off.
Note
This setting is disabled for the CCP-9000/9000A.
Enable:
When the fader lever is split, the split fader effect is enabled.
Disable:
Even when the fader lever is split, the normal fader lever effect is
obtained.
Enabling or disabling the fade-to-black function
In the
toggle between On and Off.
Note
This setting is disabled for the CCP-9000/9000A.
On:
When the [FTB] button is pressed, a fade-to-black is carried out.
Off:
Even when the [FTB] button is pressed, no fade-to-black is carried out.