Enabling or disabling aux bus control – Sony Multi Interface Shoe Adapter User Manual
Page 992

Chapt
992
Interfacing With External Devices (Device Interface Menu)
This outputs a trigger from the selected output port. This is not output when the
trigger type is “Status.”
Enabling or Disabling AUX Bus Control
1
In the Switcher >Device Interface menu, press [Aux Control].
The Aux Control menu appears.
2
Select the 9-pin port for the setting, from the
Remote1:
Make the settings for the REMOTE1 port.
Remote2:
Make the settings for the REMOTE2 port.
3
Using any of the following methods, select the AUX bus.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
a) 0: EDIT PVW
1 to 48: AUX1 to AUX48
4
Select whether to enable or disable AUX bus control from the
Enable:
enable control of the port selected in step
2
.
Disable:
disable control of the port selected in step
2
.
Manual:
make whether control of the port selected in step
2
is possible or
not depend on the setting in the Misc menu.
5
Repeat steps
2
to
4
as required to make the settings for other ports.
Setting the Interface Between the DME and the Switcher
This system has a built-in DME that can be used for the dedicated interface, but
if also using an MVE-8000A or MVE-9000 as an external DME, it is necessary
to make the settings for interfacing to the switcher.
When using the MKS-6470, no settings are necessary.
Knob Parameter
Adjustment
Setting
values
1
No
AUX bus selection
0 to 48
a)