Table of available attributes, Attribute display, Temporary attributes – Sony Multi Interface Shoe Adapter User Manual
Page 690: Bus override

Chap
690
Overview
Auto play:
Play a frame memory clip immediately after the snapshot is
recalled.
Table of available attributes
The attributes that can be used depend on the region, as follows.
Yes: Can be used No: Cannot be used
Attribute display
You can view the attributes of a snapshot in the Snapshot menu.
For more details, see “Snapshot Operations in the Menus” (page 696).
Temporary attributes
When recalling a snapshot, you can temporarily apply attributes distinct from
the attributes set for each register. These are called “temporary attributes.”
You can set temporary attributes when recalling a snapshot.
Bus override
If you recall a snapshot while holding down an A or B bus button, the selection
of the signal on the A or B bus does not change when the snapshot is recalled.
This function is called “bus override.”
This function is effective when cross-point hold is off, and you want to
temporarily maintain the cross-point setting. When cross-point hold is on, the
above operation is not necessary.
Attribute
Region
M/E-1 and PGM/PST
User 1 to User 8
DME ch 1, ch 2
Cross-point hold
Yes
Yes
Yes
Key disable
Yes
No
No
Effect dissolve
Yes
Yes
Yes
Auto transition
Yes
No
No
GPI outputs
Yes
Yes
No
Clip event
No
Yes
No
Auto play
No
Yes
No