Sony Multi Interface Shoe Adapter - Manual (Page 183)

183
Key Setting Operations With the Cross-Point Control Block
C
h
ap
te
r 4
K
e
ys
Key Setting Operations With the Cross-
Point Control Block
You can make a key signal selection using the cross-point control block of the
M/E-1 or PGM/PST bank including the relevant key.
Applying a DME Effect to a Key
Checking the DME status
As an example, to check the DME status for M/E1 key 1, hold down the key
row delegation button [KEY1] in the M/E1 bank.
While the button is held down, the [DME1] and [DME2] buttons light, and the
colors with which they light indicate the status, as follows.
Lit green: A DME is assigned to M/E1 key 1. In the M/E1 independent key
transition and transition control blocks, the transition type for KEY1 is set
to a DME wipe.
Lit amber: A DME is assigned to an M/E1 key other than key 1.
In the independent key transition and transition control blocks, the
transition type for other than key 1 of M/E-1 is set to a DME wipe.
Not lit: No DME is assigned, or a DME wipe is not selected.
You can check the DME operating status in the Status menu (see page 334).
Assigning DMEs to a key
As an example, to assign DME1 and DME2 to key 1, in the cross-point control
block, hold down the key row delegation button [KEY1] and press the buttons
([DME1] and [DME2]) for the DME channels to be used.
In this case, press [DME1], followed by [DME2].
The buttons pressed ([DME1] and [DME2]) light green and the DMEs are
assigned to key 1.
Notes
• If the DME is selected on another keyer, the later selection takes precedence
and the button lights green.
By a setting in the Setup menu
(see “Operation Settings (Operation menu)”
in Chapter 19 (Volume 3)) , you can make the first selection take precedence.
• For one M/E bank, DME effects (including DME wipes) can be used in two
places.