Sony Multi Interface Shoe Adapter - Manual (Page 669)

669
Executing Effects
Ch
a
p
te
r 1
3
K
e
yfr
a
m
e
E
ffe
ct
s
Executing an effect automatically
1
Select the region in which you want to execute the effect, using the region
selection buttons in the numeric keypad control block.
(See step 2 (page
641) of “Recalling a register.”)
2
With the numeric keypad, enter the number of the register in which the
effect you want to execute is saved, and press the [ENTER] button to
confirm.
This recalls the effect saved in the register.
3
In the keyframe control block, press the [RUN] button.
The [RUN] button lights amber and the effect is executed automatically.
Executing an effect manually
In step 3 above, operate the fader lever.
To use the transition control block fader lever as a keyframe fader
Press the [KF] button in the transition control block, turning it on, to execute a
keyframe effect with the fader lever in the same control block.
You can also assign the [KF] button to a transition type selection button in the
transition control block.
Notes
• For the operation of assigning the [KF] button to the transition type selection
buttons, see “Overall Control Panel Settings (Config Menu)” in Chapter 19
(Volume 3) .
• It is not possible for the [KF] button to be on for multiple banks (M/E or
PGM/PST) at the same time. If you press the [KF] button in more than one
bank, only the last button pressed remains on.
• If a macro is assigned to the transition control block fader lever, then while
in use as a keyframe fader the macro is not executed.
Moving to the first keyframe of the effect
To move to the first keyframe of the effect, press the [REWIND] button.
Setting the Run Mode
You can set the run mode in which an effect is executed when you press the
[RUN] button.