Sony Multi Interface Shoe Adapter - Manual (Page 979)

979
Settings Relating to Function Links (Link Menu)
Cha
p
te
r 20
Swi
tc
h
e
r S
e
tup (Swit
c
her
)
Settings Relating to Function Links (Link
Menu)
Carry out setup relating to links by displaying the Switcher >Link menu.
To display the Link menu
In the Engineering Setup menu, select VF3 ‘Switcher’ and HF6 ‘Link.’
The status area shows the current link information.
The following functions are available here.
•
Internal Bus Link: Make a setting of the bus link function that links
together two buses internal to the switcher.
• GPI Link: Make settings for linking any cross-point buttons or [CUT] and
[AUTO TRANS] buttons in the cross-point control block and GPI output
ports.
• M/E Link: Make settings to link together two M/E banks.
• Key Trans Link: Make settings to link key transitions.
Setting a Cross-Point Button Link
To link together two buses internal to the switcher, use the following
procedure.
1
In the Switcher >Link menu, press [Internal Bus Link].
The Internal Bus Link menu appears.
The status area shows the link source and link destination buses, and link
table information.
2
Using any of the following methods, select what setting applies to.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
3
Press [Link Bus Select].
The Link Bus Select menu appears.
Knob Parameter Adjustment Setting values
1 Link No Link number 1 to 64