Adjusting the video clip – Sony Multi Interface Shoe Adapter User Manual
Page 968

Chapt
968
Signal Output Settings (Output Menu)
Adjusting the video clip
To adjust the clip value for each of the output signals from the Output 1 to 24
ports, use the following procedure.
1
In the Switcher >Output menu, press [Video Clip].
The Video Clip menu appears.
The status area shows the output ports and assigned signals, and the white
clip, dark clip, and chrominance clip values.
2
Adjust the following parameters.
To set the values to the default values, press [Default].
Making vertical blanking interval adjustment and through mode
settings
1
In the Switcher >Output menu, press [V Blank/Through].
The V Blank/Through menu appears.
The status area shows the output ports and the assigned signals, the vertical
blanking interval, and the through mode Enable/Disable status.
2
Press [V Blank Mask].
3
Adjust the parameter.
a) Depending on the signal format, the adjustment range varies as follows.
•
480i:
10 to 19
•
576i:
6 to 22
•
1080i:
7 to 20
•
720P:
7 to 25
To return the values to their defaults, press [Default].
4
To enable the through mode, press [Through Mode], setting it to Enable.
The through mode can be applied to the following outputs.
Knob
Parameter
Adjustment
Setting values
2
White Clip
Luminance signal white clip value
90.00 to 109.02
3
Dark Clip
Luminance signal dark clip value
–6.85 to +10.00
4
Chroma Clip
Chrominance signal clip value
90.00 to 113.17
Knob
Parameter
Adjustment
Setting values
2
Mask End
Final value for vertical blanking
interval
See note a) below