Sony Multi Interface Shoe Adapter - Manual (Page 996)

C
hap
te
r
2
1
D
M
E Set
u
p
(
D
ME
)
996
Settings Relating to Signal Inputs (Input Menu)
Settings Relating to Signal Inputs (Input
Menu)
To make settings relating to DME input signals, display the DME >Input
menu.
To display the Input menu
In the Engineering Setup menu, select VF4 ‘DME’ and HF1 ‘Input.’
The status area shows the initial crop information and the DME system phase.
The following functions are available here.
•
Initial Crop: Make the initial crop setting.
• Matte Illeg. Color Limit: Switch the illegal limiter for the signal generated
by the DME internal matte generator on or off.
• System Phase: Adjust the operation timing of the whole system with respect
to the reference signal.
• TBC Center: Set the TBC window center position.
In the following, the settings for DME1 are explained. (It is not necessary to
make settings for DME2.)
Setting the Initial Crop
1
In the DME1 group of the DME >Input menu, select the screen
aspect ratio (16:9 or 4:3).
2
In the DME1 group, press [Initial Crop] and adjust the following
parameters.
• If you selected 4:3 in step 1
Knob Parameter Adjustment Setting values
1 Top Position of top side –3.00 to +3.00
2 Left Position of left side –4.00 to +4.00
3 Right Position of right side –4.00 to +4.00
4 Bottom Position of bottom side –3.00 to +3.00