Adjusting the dme wipe pattern cropping – Sony Multi Interface Shoe Adapter User Manual
Page 248

248
Basic Procedure for DME Wipe Settings
Ch
a) The effect size when [Size] is off is taken as 100.00%.
Display indications when multiple channels are selected at the same
time
The indications on the knobs show the settings of the lowest-numbered
channel. When you turn the knobs to adjust the settings, this changes the
settings on the other channels by the same amount.
Adjusting the DME wipe pattern cropping
Note
When pattern numbers 1701 and 1702 are selected, crop cannot be used.
1
In the M/E-1 >DME Wipe menu, select HF5 ‘Modify.’
The Modify menu appears.
2
Depending on whether the selected pattern is in one-channel mode or two-
channel mode, proceed as follows.
For a pattern in one-channel mode:
press [1st Ch], turning it on.
For a pattern in two-channel mode:
from the
the corresponding channel. You can select more than one channel at
the same time. Some patterns need no selection which is fixed in the
3
In the
4
Set the following parameters.
Display indications when multiple channels are selected at the same
time
The indications on the knobs show the settings of the lowest-numbered
channel. When you turn the knobs to adjust the settings, this changes the
settings on the other channels by the same amount.
In 16:9 mode, to crop to 4:3 aspect ratio
In the
Knob
Parameter
Adjustment
Setting values
1
Top
Crop the top of the image
–100.00 to +100.00
2
Left
Crop the left of the image
–100.00 to +100.00
3
Right
Crop the right of the image
–100.00 to +100.00
4
Bottom
Crop the bottom of the image
–100.00 to +100.00