Sony Multi Interface Shoe Adapter - Manual (Page 455)

455
DME Special Effect Operations
Chapt
er
11
DME Ope
ra
tions
Beveled Edge Settings
Applying a beveled edge
1
In the DME menu, select VF1 ‘Edge’ and HF2 ‘Beveled Edge.’
The Beveled Edge menu appears.
2
Press [Beveled Edge], turning it on.
This enables the beveled edge, and you can now use the knobs to adjust the
parameters.
Note
When the border is enabled, the edge soft function (see page 452) is not
available.
3
Set the parameters.
The valid ranges of the parameter values depend on the combination of
signal format (SD/HD) and aspect ratio (4:3/16:9) selected in the system,
as follows.
• 4:3 mode
• 16:9 mode
4
In the group, select the type of edge.
Light: effect of light striking the edge
Knob Parameter Adjustment Setting values
1 H Simultaneously adjust width of left
and right edges 0.00 to 4.00 (SD)
0.00 to 12.00 (HD)
2 V Simultaneously adjust width of top
and bottom edges 0.00 to 4.00 (SD)
0.00 to 12.00 (HD)
3 All Simultaneously adjust width of all
four edges Value of H shown
Knob Parameter Adjustment Setting values
1 H Simultaneously adjust width of left
and right edges 0.00 to 4.00 (SD)
0.00 to 16.00 (HD)
2 V Simultaneously adjust width of top
and bottom edges 0.00 to 2.25 (SD)
0.00 to 9.00 (HD)
3 All Simultaneously adjust width of all
four edges Value of H shown