Sony Multi Interface Shoe Adapter User Manual
Page 736
736
Macro Operations in the Numeric Keypad Control Block and the Keyframe Control Block
Ch
• To move to an edit point by specifying an event number (the number
showing the position of the event in the macro execution sequence),
press the [GO TO KF] button in the keyframe control block, then in the
numeric keypad control block, enter the target number and confirm with
the [ENTER] button.
Inserting an event
1
Specify the edit point.
(See
)
2
If required, press the [AUTO INS] button assigned to a utility/shotbox
control block or user preference button, to toggle the auto insert mode on
or off.
3
Create the event.
is on, the event is automatically
added to the macro.
• When auto insert mode is off, proceed to step
4
.
4
When auto insert mode is off, press the [INS] button in the keyframe
control block.
5
Repeat steps
2
and
3
to insert the required events in the macro.
Modifying a single event
1
Specify the edit point.
(See
)
2
When the [AUTO INS] button assigned to a utility/shotbox control block
button or user preference button is lit, press this to turn the auto insert mode
off.
3
Create the event.
4
Press the [MOD] button in the keyframe control block.
Modifying a particular range of events
1
Carry out steps
1
to
3
of the procedure in
“Modifying a single event” (the
previous item).
2
Press the [FROM TO] button in the keyframe control block, turning it on.