Sony Multi Interface Shoe Adapter User Manual
Page 70
70
Names and Functions of Parts of the Control Panel
Ch
apt
For details, see “Basic Operations” in
Chapter 11 (Volume 2).
When the VTR/disk recorder/frame
memory operation mode is enabled
The Buttons are used for VTR control or
playback of frame memory clips.
For details, see “Controlling the Tape/Disk
Transport” in Chapter 12 (Volume 2).
When the resizer control mode is enabled
LOCAL (K1):
Select key 1.
GLB (K2):
Select key 2.
LOC SIZE (ASP: aspect):
Pressing this
button and operating the trackball or Z-
ring changes the aspect ratio of a key to
which the resizer function is applied to.
When this button is held down, the
trackball or Z-ring operation is
switched to a finer control. (fine mode)
LOC XYZ (LOC: location):
Pressing this
button and operating the trackball or Z-
ring moves, shrinks, or magnifies a key
to which the resizer function is applied
to. When this button is held down, the
trackball or Z-ring operation is
switched to a finer control. (fine mode)
ROT (RSZE: resizer):
Press this button,
turning it on, to enable the resizer.
CLR WORK BUFR (clear work buffer):
Pressing this button once returns the
two-dimensional transformation
settings to the defaults. Pressing twice
in rapid succession returns all resizer
parameter values to the defaults.
X, Y:
These restrict the axes affected by the
trackball and Z-ring to the x- or y-axis.
Z:
This restricts the axes affected by the
trackball and Z-ring to the z-axis.
CTR (center):
Pressing this button once
changes the two-dimensional
transformation settings to the closest
detent values. Pressing twice in rapid
succession returns the two-dimensional
transformation settings to the defaults.
c
Trackball
When the positioner operation mode is
enabled
By moving this, you can move the pattern
in the x-axis and y-axis directions.
When the three-dimensional transform
operation mode is enabled
Move the trackball to control the x- and y-
axes in a three-dimensional transform.
When the [SRC] or [TRGT] button is held
down, the trackball operation is switched to
a finer control. (fine mode)
When the resizer control mode is
enabled
By turning the trackball, you can move in
the x- and y-directions of the key to which
the resizer is applied, and change the aspect
ratio.
When the [LOC SIZE] or [LOC XYZ]
button is held down, the trackball operation
is switched to a finer control. (fine mode)
d
Z-ring
When the positioner operation mode is
enabled
When the [USER] button is selected, by
turning the ring you can adjust the size of
the pattern.
When the three-dimensional transform
operation mode is enabled
Turn this ring to control the z-axis in a
three-dimensional transform.
When the [SRC] or [TRGT] button is held
down, the Z-ring operation is switched to a
finer control. (fine mode)
When the effect run control mode is
enabled
By turning the Z-ring, you can run the
keyframe effect, independent of the STOP
NEXT KF, EFF LOOP, and similar settings
in the keyframe control block. Turn
clockwise to run the effect in the normal