Sony Multi Interface Shoe Adapter - Manual (Page 666)

Chapt
er
1
3
K
e
y
fra
me Ef
fe
c
ts
666
Path Setting
At this point, depending on the setting for Curve, the effect for Hue and
Xpt is also affected as shown in the following table. In the menu, the Hue
and Xpt settings do not change, but the path type indication is dimmed out.
4
If you selected Spline as the path type, set the following parameters, using
the knobs.
Changing the path type for Hue
1
Press the Hue path type indication for the item that you want to change.
2
Turn knob 1 to change the Hue path type.
The path type indications shown in the menu represent the change in hue
as seen on a Vectorscope.
CW: Rotate clockwise.
CCW: Rotate counterclockwise.
Short: The hue changes in whichever of the clockwise and
counterclockwise directions is shorter.
Long: The hue changes in whichever of the clockwise and
counterclockwise directions is longer.
Changing the path type for Xpt
1
Press the Xpt path type indication for the item that you want to change.
A path selection window appears.
2
Press the indication for the desired path type, to select it.
Xpt Hold off: When replaying a keyframe, change the inputs to the
settings saved in memory.
Curve setting Hue change Xpt change
OFF Does not change Hold
Step Changes as with the Step setting Is not affected
Knob Parameter Adjustment Setting values
1 Tens Spline interpolation tension –4.00 to +4.00
2 Bias Spline interpolation bias –4.00 to +4.00
3 Cont Spline interpolation continuity –4.00 to +4.00