Sony Multi Interface Shoe Adapter User Manual
Page 693
693
Snapshot Operations From the Numeric Keypad Control Block
Cha
6
To apply attributes, press the following buttons, turning them on.
a) The GPI port that can be set is 1 (fixed).
For details of attributes, see “Snapshot Attributes” (page 689).
Note
In the numeric keypad control block, it is not possible to apply the cross-
point hold.
For details, see “Applying snapshot attributes” (page 696)
.
7
Press the [ENTER] button.
This saves the snapshot, and the [STORE] button goes off. The [RCALL]
and [STORE STATS] buttons light.
To cancel a snapshot save operation
After saving a snapshot, to cancel the save, hold down the [STORE STATS]
button and press the [UNDO] button.
Recalling a snapshot from the numeric keypad control block
1
In the numeric keypad control block, press the [SNAPSHOT] button,
turning it on.
This allocates the numeric keypad control block to snapshot operations,
and the [RCALL] button lights.
2
Press the region selection button corresponding to the region you want to
recall, turning it on. Multiple selections are also possible.
[M/E 1], [P/P]:
These select the M/E-1 and PGM/PST regions.
[USER 1] to [USER 8]:
These select the User regions.
[DME 1], [DME 2]:
These select the DME channels.
[RTR]: This selects the Router region.
[ALL]:
This selects all regions.
[MASTR]:
This selects a master snapshot.
Note
The regions that can be selected simultaneously are those assigned to the
region selection buttons in the numeric keypad control block.
(See
Attribute to apply
Button
Effect dissolve
[+/–/EFF DISS] button
Auto transition
[CLR/AUTO TRANS] button
GPI output
a)
TRIM/GPI ENBL] button